Click Here to Receive DIY Electrical Wiring Help from a Master Electrician
 

Top

Trying to Hook Up a Generator Without a Transfer Switch

January 16, 2007

Q: I live on a farm and want to install a generator. My electrical meter is outside on a hydro pole, and it has a master shutoff below the meter. The breaker box inside of the house also has a master breaker shutoff on it, its a 100 amp. If I shut off both master breakers, and hook the generator into house circuit at the main breaker box, there wouldn’t be any feedback into main supply hydro line, that the hydro repair men could be injured at all, or would there be.

A: In theory this will work. However, this is not safe and it is a National Electrical Code (NEC) violation. Depending on where you live this could also be illegal. Here in Montana, the NEC has been adopted into legislation and this would be illegal here.

The problem with just turning off your breakers is that mistakes can be made. You may forget to turn off your breakers or the breaker could be bad and not turn off which would allow the power to backfeed into the utility line. 

You are required to install a transfer switch between the meter/disconnect on the pole and your breaker box. We typically install these right next to your breaker box. Using a transfer switch is the only safe and legal way to wire a back-up generator into your electrical system. Transfer switches can be tricky to install and I highly recommend hiring a licensed electrician that is experienced at installing generators.

If you have a portable generator and no transfer switch, the only safe way to use this is by running extension cord(s) from your generator to the appliance(s) you want to work off of your generator during the power outage.

DIY Electrical Wiring Help from a Master Electrician Do you need assistance with your electrical wiring project? Please visit my DIY Electrical Wiring Help from a Master Electrician page. Where I provide electrical wiring tips, expert electrical advice, answers to your electrical questions and electrical consulting & design services over the phone, via instant messenger or via email.

If you enjoyed this post, make sure you subscribe to my RSS feed or receive updates via email. You can also follow me on Twitter and "LIKE" me on Facebook.

Similar Posts:
Site Sponsor
The Electrical Tool Store - Your online source for electrical wi


Comments

2 Responses to “Trying to Hook Up a Generator Without a Transfer Switch”

  1. james jones on May 9th, 2008 11:44 am

    how do I connect a gen to a hous below the meter i can hook the gen to braker box but this is not what i want i need a picture digram of how to hook a gen to the bottom of the house meter

  2. Bill on April 22nd, 2011 2:56 pm

    How can I hook up a generator to my breaker panel? There are no wires coming in from the pole…the house has no electricity service at all…just the panel with no meter….thanks…Blane :)

Do you have a question or idea to add to this post? Feel free to post it below. Due to a large backlog and an overwhelming response, it takes approximately 30 days to receive an answer to your electrical question for free. Simply subscribe to this blog (use one of the subscription methods listed in the top right corner of this page) and your answer will be listed in a new blog post in the near future.

To receive an immediate answer (in less than 24 hours) please visit my DIY Electrical Wiring Help from a Master Electrician page.






four × 9 =

Bottom