The Electrical Tool Store - Electrical Wiring Tools, Coax Cable Installation Tools and Phone & Data Wiring Tools
 

Top

How Many Receptacles Are Allowed On A 20 Amp Circuit?

March 22, 2006

Q: According to the National Electrical Code, 10 receptacles are permitted on a 15A branch circuit and 13 are permitted on a 20A branch circuit in commercial buildings. How many receptacles are permitted on a 20A branch circuit in a single family home?

A: There is no limit to the number of receptacles permitted on a 20A branch circuit in a single family home. For other than dwelling units, part (a) of 220.3(B) requires that each single or multiple receptacle on the same yoke be calculated as a load of 180VA, or a receptacle outlet that has four or more receptacles be counted at 90VA for each receptacle. Using this load of 180VA for each single or duplex receptacles allows 10 receptacles on a 15A branch circuit and 13 on a 20A branch circuit.

In residential occupancies receptacles are required to be spaced at fixed intervals; this is not the case for commercial occupancies. In commercial, industrial, institutional, etc. occupancies receptacles are generally located only where required to supply cord-and-plug connected loads. For this reason, unit loads are assigned to receptacles in other than residential occupancies. The Code mandates spacing of receptacles in dwelling units to provide flexibility in the use of table lamps, floor lamps and other appliances and to reduce the use of exterior cords; not because there will be loads plugged into every receptacle.

In all occupancies 210.11 requires an adequate number of branch circuits for the calculated loads. And 210.11(B) require that the calculated load be evenly divided among the branch circuits.

Some inspection authorities have local laws or ordinances that limit the number of receptacle outlets on 15 and 20A branch circuits in residences. I am not in favor of such a regulation, but you should be aware of such a restriction if one exists.

DIY Electrical Wiring Help from a Master Electrician Do you need assistance with your electrical wiring project? Please visit my DIY Electrical Wiring Help from a Master Electrician page. Where I provide electrical wiring tips, expert electrical advice, answers to your electrical questions and electrical consulting & design services over the phone, via instant messenger or via email.

If you enjoyed this post, make sure you subscribe to my RSS feed or receive updates via email. You can also follow me on Twitter and "LIKE" me on Facebook.

Similar Posts:
Site Sponsor
The Electrical Tool Store - Your online source for electrical wi


Comments

One Response to “How Many Receptacles Are Allowed On A 20 Amp Circuit?”

  1. Joe Krupa on July 30th, 2008 10:35 pm

    I would like to add one, possibly two kitchen countertop receptacles. I have two existing ones, both 20 amps. Receptacle A, on the left, has not been tapped into. Receptacle B, on the right, includes the fridge receptacle, making a total of two receptacles on this circuit. Do I run a new devoted 20 amp circuit, or can I branch off of Receptacle A ??? My community observes the NEC, but it is not clear to me regarding this situation. I would greatly appreciate your insight…

Do you have a question or idea to add to this post? Feel free to post it below. Due to a large backlog and an overwhelming response, it takes approximately 30 days to receive an answer to your electrical question for free. Simply subscribe to this blog (use one of the subscription methods listed in the top right corner of this page) and your answer will be listed in a new blog post in the near future.

To receive an immediate answer (in less than 24 hours) please visit my DIY Electrical Wiring Help from a Master Electrician page.






nine − 2 =

Bottom